Good evening all,
The following is an excerpt taken from our SSR Storm Chasing Safety Manual. Unfortunately I cannot insert the diagrams, however the text can sufficiently outline the way we do it!.
Best regards
Kris.
EXCERPT FROM STORM CHASING SAFETY MANUAL - SEVERE STORMS RESEARCH (SSR)
WHEN STOPPING FOR PHOTOGRAPHS / VIDEO / VIEWING AND SETTING UP INSTRUMENTS
1. Ensure Vehicle is sufficiently removed from highway, and that it is visible to all traffic. At night, use Electro-flares and strobes if necessary. ONLY use beacon for emergency purposes
2. Ensure all personnel and equipment are safe from potential Lighning Strike
3. Ensure all personnel are briefed prior to transit and again once inside areas of elevated risk.
3. Determine risk involved in positioning module, and/or South-aligning the Anemometer shaft. If risk is too high, STAY INSIDE VEHICLE. Also if risk is too high to exit vehicle to align, consider re-positioning the vehicle. If neither is an option, ensure that a compass reading coupled to a comprehensive sketch (or preferably a photo) is taken of your location and position relative to any plainly identifiable landmark, thus facilitating directional compensation later on.
4. Ensure any persons exiting the vehicle at night, or during low visibility, are wearing reflective hi-visibility jackets.
5. Equipment is replaceable – DO NOT take any risks associated with attempting to save equipment. Again, you must ONLY exit the vehicle if it is not considered dangerous to do so.
6. In the event that a person (or persons) is struck by lightning, get IMMEDIATE emergency assistance, administer First Aid, (Remember DR ABC – D is for Danger), DO NOT approach affected person if there are still lightning strikes in the immediate or close vicinity, instead, attempt to place the vehicle immediately alongside the person to effect a safe retrieval.
PRE-PLANNING TASKS AND RESPONSIBILITIES BEFORE COMMENCING TRANSIT
1. It is essential that everybody involved fully understands their own specific responsibilities during the transit period, right through to unloading equipment at ‘reccy’ sites. Ask all persons if they have First aid capabilities, make sure those whom have are identified to everybody
2. Ensure that the nominated driver is a person whom has the trust of the entire group, and whom will concentrate on the task of driving despite the many distractions that may occur, it sounds straightforward, but many more accidents happen due to driving inattention than are caused by any facet of a storm
3. Ensure the navigator has all relevant maps, and takes time to study main roads around the region prior to commencement of the chase. Ensure that the navigator has an area available during transit where he/she can unfold and read maps without affecting the driver. It is often best that the navigator sit in the rear of the vehicle. In our F100, there is a specifically designed nav area complete with map storage, lighting and a small table. Attention to detail is imperative, and the navigator can be the difference between success and failure.
4. Instrumentation set up is the responsibility of SSR, data logging is done automatically into the laptop. “Live” data is viewable on the laptop in the front of the vehicle, and on the head unit of the wx station, which is located at the navigators station. REMEMBER, the wind direction readings are only valid after South alignment has been performed after the vehicle has stopped.
5. Prior to travel, ensure all First Aid and safety / emergency equipment, including phones and radios is present and in good order. Perform a walk round check of the vehicle prior to transit. It is anticipated that oil/water and batteries etc, would have been checked prior to loading. The driver must perform a brakes check prior to transit